Product Information Sheet
GOLDEN Logo
 
LINEN

 

Golden Artist Colors, Inc.
188 Bell Road
New Berlin, NY 13411-9527 USA
Toll Free: 800-959-6543
Fax: 607-847-6767
techsupport@goldenpaints.com
www.goldenpaints.com

PAINT PRODUCTS:

Latex Semi-Gloss Base Color: Taupe
Glaze: Ivory

BRUSHES AND TOOLS:

1/4 Nap Roller
Dragging Brush
Note: See APPLICATION INFORMATION SHEET: Decorative Painting Tools

PAINTING INSTRUCTIONS:

Step 1 (2170 bytes)
Rolled base is applied.
Step 1:
Roll Base Color over the entire surface.
Let dry.

 

Step 2 (6776 bytes)
The lighter section has
been dragged one way.
Step 2:
Roll glaze evenly onto the surface.
Cover an area from floor to ceiling no wider than you can reach.
Do not allow to dry.

 

Step 3 (5659 bytes)
You can see that the brush has been dragged both ways.
Step 3:
Working from top to bottom, use the Dragging Brush with bristles held parallel to the surface.
Pull the brush through the wet glaze.
Let dry.

 

Step 4 (4402 bytes)Step 4 (6275 bytes)
Step 4 (6084 bytes)Step 4 (5690 bytes)
The completed product in a few colors
.
(Will take time to load)
Step 4:
Repeat step 3, but drag the brush in a vertical direction.

TIPS:

  • Keep your brush clean to prevent glaze from building up. This may be done by wiping the brush onto paper towels after each pass.
  • Work with a partner for easier application. One person will apply glaze while the other person drags with the brush.
  • Try dragging in different directions to get different effects.


APPLICATION IDEAS:

A good overall technique. Decorate walls, or below chair rails. This is also a good technique for paneled doors and cabinets.

DISCLAIMER

The above information is based on research and testing done by Golden Artist Colors, Inc., and is provided as a basis for understanding the potential uses of the products mentioned. Due to the numerous variables in methods, materials and conditions of producing art, Golden Artist Colors, Inc. cannot be sure the product will be right for you. Therefore, we urge product users to test each application to ensure all individual project requirements are met. While we believe the above information is accurate, WE MAKE NO EXPRESS OR IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, and we shall in no event be liable for any damages (indirect, consequential, or otherwise) that may occur as a result of a product application.