2008-6 CHA
Panel #6:
Jeweled Medallion

Printer Friendly Version

GOLDEN Products:

• Fluid Colors: Titanium White, Naphthol Red Medium, Cerulean Blue Deep
• Coarse Molding Paste
• Soft Gel (Matte)
• Clear Tar Gel

Other Components:

• ATC Trading Card Panel
• Fleur de Lis style stamp

Step 1: Apply a basecoat of Titanium White mixed with Naphthol Red Medium. Let dry.

Step 2: Spread a layer of Coarse Molding Paste over the basecoat. While still wet, press a foam rubber stamp into the gel.  Remove stamp immediately*. Let dry.

Step 3: Apply a wash of Cerulean Blue Deep over the dry Coarse Molding Paste. Let dry.

Step 4: Use Soft Gel (Matte) to glue a selection of beads onto the board.

Step 5: Apply a layer of Clear Tar Gel to entire surface, sealing in the beads.

*NOTE: Always clean stamps thoroughly immediately after using with acrylics. If the acrylic is allowed to dry, it could permanently adhere to the stamp.

Disclaimer

The above information is based on research and testing done by Golden Artist Colors, Inc., and is provided as a basis for understanding the potential uses of the products mentioned. Due to the numerous variables in methods, materials and conditions of producing art, Golden Artist Colors, Inc. cannot be sure the product will be right for you. Therefore, we urge product users to test each application to ensure all individual project requirements are met. While we believe the above information is accurate, WE MAKE NO EXPRESS OR IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, and we shall in no event be liable for any damages (indirect, consequential, or otherwise) that may occur as a result of a product application.