Paint Products:

• Light Molding Paste

Brushes and Tools:

• Spackle knife
• Stencil: #SG from Charterhouse Design, Inc.
  157 Charterhouse Cres., Ancaster, ON  L9G 4M4
  Ph: 905 648 9843 charterhousedesign@earthlink.net

Painting Instructions:

Step 1.  Secure stencil to surface.

Step 2.  Apply Light Molding Paste with spackle knife over stencil, smoothing until satisfied.

Step 3.  Remove stencil immediately.  Allow to dry.

Clean Up:  Wash hands and tools in soap and water.  Keep tools wet while working to prevent permanent adhesion of the acrylic materials.

Surface Preparation:

General: A clean, wax free, non-greasy surface is recommended.  High gloss surfaces may need scuffing to improve adhesion.  GOLDEN Glaze is formulated to work best over a satin sheen base coat.  Gels and texture products may be put over any sheen base coat.

Masonry/Stucco: New masonry needs to be fully cured and primed with a suitable masonry primer.

Wood: Raw wood may be painted or stained directly, but be aware that water based materials can cause grain raising.  See “General” instructions above for guidance on previously painted surfaces.

Metal: Painting direct to metal requires a suitable primer for the specific metal type.  See “General” instructions above for guidance on previously painted surfaces.

Glass: Painting direct to glass is possible; primers and GOLDEN GAC 200 aid in adhesion.

Fabric, Canvas, and Paper: Paint direct or use GOLDEN Mediums as a size, to increase launderability or seal the surface.

If you have any other questions please feel free to contact us at the number below.

Important: Golden Artist Colors provides these recipes as points of departure for exploring Golden products in faux finishing applications.

GOLDEN strongly recommends samples be created before attempting to apply these techniques to walls, some techniques will be difficult to remove or to cover at a later date.

Please contact the technical support team before application if there are concerns or questions at 1-800-959-6543.