2006-1 CHA
Molding Paste:
Lace Stencil

Printer Friendly Version

Paint Products:

• Fluid Acrylic Cobalt Teal
• Fluid Acrylic Permanent Violet Dark
• Molding Paste

Brushes and Tools:

• Lace Fabric
• Palette Knife
• Sponge Brush/Foam Roller

Painting Instructions:

Step 1.  Basecoat the surface with Fluid Cobalt Teal using a foam roller or
sponge brush.  Allow to dry.

Step 2.  Lay the lace across the surface and tape edges down to secure the lace from moving.  Next, mix Molding Paste and Fluid Permanent Violet Dark at a 2:1 ratio.  Using your palette knife, spread the mixture over the lace at desired thickness (1/4” is good).  Make sure the top of the mixture is smooth.  Pull the tape up from the edges of the lace, then lift the top corners of the lace and slowly pull the lace up.  Be careful not to drop the lace back into the wet Molding Paste.  Allow to dry.

Important: Golden Artist Colors provides these recipes as points of departure for exploring Golden products in faux finishing applications.

GOLDEN strongly recommends samples be created before attempting to apply these techniques to walls, some techniques will be difficult to remove or to cover at a later date.

Please contact the technical support team before application if there are concerns or questions at 1-800-959-6543.

Disclaimer for Decorative Technique Sheets

The above information is based on research and testing done by Golden Artist Colors, Inc., and is provided as a basis for understanding the potential uses of the products mentioned. Due to the numerous variables in methods, materials and conditions of producing art, Golden Artist Colors, Inc. cannot be sure the product will be right for you. Therefore, we urge product users to test each application to ensure all individual project requirements are met. While we believe the above information is accurate, WE MAKE NO EXPRESS OR IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, and we shall in no event be liable for any damages (indirect, consequential, or otherwise) that may occur as a result of a product application.