Printer Friendly Version

Coarse Molding Paste & Cheesecloth with Printed Image

GOLDEN Products:

• Coarse Molding Paste 
• Digital Ground White (Matte)

Other Components:

• Polyethylene plastic sheeting
• Cheesecloth
• Painter’s tape
• Plain printer paper

Step 1. Lay a piece of polyethylene plastic on a flat surface. Lay an appropriately sized piece of cheesecloth on the plastic. Using a broad palette knife or spatula, spread GOLDEN Coarse Molding Paste onto the cloth. Using pressure, scrape the paste into the weave of the cloth, removing excess Coarse Molding Paste. Let dry.

Step 2. Using a brush, coat the substrate with GOLDEN Digital Ground White (Matte). Apply two coats in opposite directions, allowing each coat to thoroughly dry between applications.

Step 3. By carefully lifting a corner and pulling up, remove the Coarse Molding Paste substrate from the plastic. A razor blade can sometimes be helpful to lift the edge of the skin.

Step 4. In preparation for printing, secure the skin to a carrier (painter’s tape and plain printer paper work well). Put the secured skin into the printer’s paper path.

Step 5. Print desired digital artwork or photograph onto the skin through an ink-jet printer. Remove from the carrier and use as desired.

For more information see the other topics available on www.goldenpaints.com/mixmoremedia.

Go Back to Applications

Go Back to Mix More Media